ATI Technologies FIRE GL1 User's Guide download pdf (Page 17)

Installing Fire GL1 17

After Installing the Card

If you have correctly installed the card, operating system messages

will appear on your monitor when the boot procedure is finished.

To enjoy the full benefits of your new Fire GL1 card in your PC,

you will need to install a package of basic drivers. Refer to Installing

Software.

To enable and set up a multi-monitor configuration use the

MultiScreen

dialog in the

Display Properties

menu after you

have installed the FireGL1 drivers.

If your system does NOT boot as it should...

♦

Check again to verify that the installation instructions were

properly followed.

♦

Check that the system BIOS has assigned a system interrupt to

the AGP or PCI slot where the card is installed.

⇒

Check the system configuration utility of your operating

system for the interrupt assignments.

⇒

Inspect your system BIOS setup for an option that says

"Assign IRQ to VGA" or something similar and ensure that

this option is enabled.

♦

Some older ISA legacy add-in cards (with jumpers, non-Plug-

n-Play) may cause a conflict if they are not configured in the

ESCD (extended system configuration data) area of the system

BIOS. Please refer to your computer’s User’s Guide for

information on using the ISA Configuration Utility ICU to add

legacy card resource requirements to the system.

♦

Contact the Technical Support.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 58 59

No comments

ATI Technologies FIRE GL1 User's Guide Page 17